******** Information for custom setting the driver ********* ****** for SONY ATAPI CD-ROM Drive CDU55D/E ****** To install device driver in config.sys: device=atapi_cd.sys /d:mscd000 /d: Specifies device driver name. Used by MSCDEX. This is the current value if none is specified in config.sys. /Q This re-enable the interrupt mask for IDE. This bit is used when IDE harddisk is using IDE interrupt on the same bus with CD-ROM drive. If long delay is shown when the accessing IDE HD after aceesing CD-ROM drive, Adding this switch may solve the delay. lastdrive=z Last valid drive letter. DOS defaults to 'e'. If you have 3 or more hard disks, or ram disks, this must be used to expand the number of letters available. To install Microsoft CD-ROM Extensions via autoexec.bat: mscdex /d:mscd000 /l:m /d: Name of CD-ROM device driver. Must match the value specified in config.sys. This is the name recommended by Microsoft. /l: Specifies the drive letter to use for the CD-ROM. If this, '/l:m' is not here, the next available drive letter is used. ****************************************************************************** NOTES for CDPLAY Ver.2.1 1. If the program starts under DOS/V J mode, it automatically switches the screen mode to English from DOS/V J mode, and restores it before exiting. 2. Control file (CDPLAY.CTL) is not necessarily required. When the file does not exist, the program automatically scans the valid CD-ROM drive. 3. The program can be terminated by Esc key at any time. ****************************************************************************** NOTES for Jumper Switch setting on the drive There is a jumper switch on the back of ATAPI Drive for selecting Master/Slave drive. Please make sure that you set jumper pin on the correct side for your computer. If you already have IDE Harddisk Drive in you computer and install the ATAPI Drive on the same cable, CD-ROM drive must be a slave. ******************************************************************************