copied from packet:
  Msg# TSF   Size #Rd  Date  Time  Arrived Seq #      Msg ID      Route

  1020 BF    1405   0 22-Sep 2223z 29-Sep (033727 - 26390_KB2NEX) []
  N2ROC  ==>  ALL@USBBS
  "ALINCO FULL BAND MODIFICATION"

          Alinco DR1200T Full Band Modification

Step 1.  Remove 2 screws located on top of cover.
Step 2.  Loosen the 4 screws on both sides of top cover (do not remove).
Step 3.  Remove top cover
Step 4.  Locate Yellow wire Loop behind tuning Knob (this wire loops from
         the control board mounted on front pannel).
Step 5.  Cut loop and tape ends.
Step 6.  Replace top cover.
Step 7.  Reset radio (press 'F' and VCO/M keys together.  While holding
         down keys turn off and on Power).

Factory settings will be restored however the new frequency range will
be from 132 to 173 MHz.  Any memory will have to be reprogramed.
These insructions are from Alinco, I've done them to my set and
it works great.

*** END OF MSG # 26320 from N2ROC @ KB2NEX.#NYC.NY.USA.NA
=========================================================================
Note: I haven't tried or verified this, proceed at your own risk. WA2ISE
